Hydrotech 565BM-100, Инструкция по установке и эксплуатации

Страница: 13 / 24

Automatic Raw Water Bypass During Regeneration
The regeneration cycle can last 30 minutes after which filtered water service will be re-
stored. During regeneration, un-filtered water is automatically bypassed for use in the
household. Hot water should be used as little as possible during this time to prevent un-
filtered water from filling the water heater. This is why automatic regeneration is set for
sometime during the night and manual regenerations should be performed when little or no
water will be used in the household.
Normal regeneration time is 12:00 AM.
New Sounds
You may notice new sounds as your filter operates. The regeneration cycle lasts up to 30
minutes. During this time, you may hear water running intermittently to the drain.
Manual Bypass
In the case of emergency you can isolate your water filter from the water supply using the
bypass valve located at the back of the control. In normal operation the bypass is open with
the on/off knobs in line with the inlet and outlet pipes.
To isolate the filter, simply rotate the knobs counter clockwise (as indicated by the word BY-
PASS and arrow) until they lock. You can use your water related fixtures and appliances as
the water supply is bypassing the filter. However, the water you use will be hard. To resume
water service, open bypass valve by rotating the knobs counterclockwise.
System Configuration
Tank Size (Diameter)
Drain Line Flow
Control (DLFC)
8" #5 (3.5 GPM)
9" #A (5.0 GPM)
10" #A (5.0 GPM)
12" #B (7.0 GPM)
14" #C (10.0 GPM)
16" none
Suggested Filter Valve Configuration
13