Page 43
autocut 5-32cts user manual edItIon II 2015-01-16
1. loosen the two screws at 1.
2. dismantle the worn out belt.
3. assemble the new belt (check the arrow for
correct direction of rotation).
4. pull the tension arm to correct belt tension*
5. tighten the screws in position 1.
6. check belt tension* over again.
*The belts should be tensed not more than that
you easily can move them one belt thickness in
and out at a point between the end wheels.
6.6 Adjust hose prebend angle
prebending is essential to achive a good cutting result but too much prebend will cause a
hosecut out of angle, and too little prebend can cause a cutting blade overheat. prebend
flap angle can be adjusted with screw A. Measure the depht distance to the endstop as in
illustration below.
default value is 50 mm but adjustment may be accuired depending on type of production
in the machine.
When adjusting the prebend angle, make sure that prebend cylinder sensor (lower) detect
the new end stop position, adjust the sensor if needed.
.
HYDROSCAND MACHINE AB
Kungsvägen 22
Phone: +46 (0)225 - 573 30
S-783 35 Säter
Fax:
+46 (0)225 - 501 08
Sweden
Web:
www.hydroscand-machine.se
Edition 7-00
MANUAL-E
Page 33
8.5 Change of drive belts
Drivebelt 1110mm (movable side)
A
B
1.
Loosen the 4 screws A.
2.
Loosen screw B.
3.
Loosen the 4 screws C.
4.
Disconnect the encoder plug D.
5.
Lift the complete unit to a workbench.
6.
Dismantle the worn out belt and replace it
with the new one. Make sure that the
direction of rotation for the belt (marked with
an arrow) will be right.
7.
Assemble the plate in reverse order.
8.
Adjust to correct belt tension* with screw B
9.
Tighten screws at A.
10.
Check belt tension* over again.
C
1.
Loosen the two screws at 1.
2.
Dismantle the worn out belt.
3.
Assemble the new belt (check the arrow for correct direction of rotation).
4.
Pull the tensionarm to correct belt tension*
5.
Tighten the screws in position 1.
6.
Check belt tension* over again.
1
1
Drive belt 1140mm (fixed side)
*The belts should be tensed not more than that you easily can move them one belt
thickness in and out at a point between the end wheels.
D
HYDROSCAND MACHINE AB
Kungsvägen 22
Phone: +46 (0)225 - 573 30
S-783 35 Säter
Fax:
+46 (0)225 - 501 08
Sweden
Web:
www.hydroscand-machine.se
Edition 7-00
MANUAL-E
Page 34
8.6 Adjust hose prebend angle
Prebending is essential to achive a good cutting result but too much prebend will cause a
hosecut out of angle, and too little prebend can cause a cutting blade overheat.
Prebend flap angle can be adjusted with screwA.
Measure the depht distance to the endstop as in illustration below.
Default value is 50mm but adjustment may be accuired depending on type of production in
the machine.
When adjusting the prebend angle, make sure that prebend cylinder sensor (lower) detect
the new endstop position, adjust the sensor if needed.
A
