HydraMaster Titan H2O Kubota, Руководство пользователя

Страница: 45 / 82

6-5: Systems Troubleshooting
Excessive noise produced by the blower 4.
Possible Cause Solution
4.1. The blower is low on oil. Inspect the oil levels and replenish as necessary.
Note: Running the blower with low oil levels can
cause severe damage. If this situation occurs the
blower should be inspected by a qualified service
technician.
4.2 The vacuum blower has
internal damage.
Refer to a qualified service technician.
The vacuum blower is locked and will not turn 5.
Possible Cause Solution
5.1. Truckmount has been
inactive for a period of
time and the blower was
not properly lubricated
prior to final shutdown.
Rust has possibly built up
on the internal surfaces.
Spray penetrating oil into the blower and let sit for at
least one hour. Then very carefully use pipe wrench
on the outer diameter of the pulley on the coupler
to attempt to free lobes of the blower. Do not use a
wrench directly on the blower shaft.
If unable to free up the blower in this manner, refer
to a qualified service technician.
5.2. There is internal damage
to the blower
Refer to a qualified service technician.
Water in exhaust 6.
Possible Cause Solution
6.1. The recovery tank has
been filled with foam or
overfilled with water.
Inspect the recovery tank. If full, drain the tank.
Inspect the high level shutoff switch for proper
operation. Clean or replace the switch as necessary.
6.2. Condensation in system This will be more common in cool weather and
humid climates. If this is the cause it should
dissipate after a few minutes of running.