HydraMaster Titan H2O Kubota, Руководство пользователя

Страница: 32 / 82

Machine Maintenance: 4-6
Always maintain a 50% solution of phosphate-free antifreeze at all times for
adequate heat dissipation, lubrication and protection from freezing. Major brands
are typically low phosphate or phosphate free, and will be labeled accordingly
on the container. It is recommended that you consult the technical data sheet
for the brand of coolant you are using to determine if it meets the low phosphate
requirement. failure to use a 50% solution of phosphate-free antifreeze may
result in corrosion of the cooling system.
bleeding Air from Cooling System
It is necessary to remove all of the air from the engine to prevent overheating. If the coolant
has been drained for any reason, it will be necessary to follow the bleed procedure.
When the engine is cold, remove the radiator cap. fill the radiator until it is to the top of
the filler neck. Start the engine and run in the idle rpm position and no vacuum load. Allow
the engine coolant to heat up and open the thermostat several times. As all the air is
removed from the system, the level of the radiator should lower below the internal tubes.
This process should take approximately 5 - 10 minutes. Top off the coolant and install the
cap. In the event you experience a coolant shutdown due to overheat, allow the machine
to cool down and repeat this procedure.
Radiator
Inspect the exterior of the radiator for obstructions. Remove all debris with a soft brush or
cloth. Use care to avoid damaging the core fins.
Fuel Filter
The fuel filter is located between the fuel pump and the fuel tank underneath the vehicle.