HydraMaster The Master's Touch TMT 3000, Руководство пользователя

Страница: 5 / 119

TMT 3000 Owner’s Manual - iv
list of figures
figure 1-1. Hard Water Map of Mainland united States .......................................1-15
figure 2-1. location of Roof Vents in Vehicle ........................................................2-1
figure 2-2. Recommended location of TMT 3000 in Van ......................................2-3
figure 2-3. Install fuel Pump, Outlet Side up.........................................................2-6
figure 2-4. fuel Pump Must Be in Vertical Position ................................................2-6
figure 4-1. TMT 3000 Dash Assembly - View 1 of 2 ...............................................4-1
figure 4-2. TMT 3000 Dash Assembly - View 2 of 2 ...............................................4-2
figure 4-3. location of Chemical Pump Shutoff Valve ............................................4-3
figure 4-4. Chemical Pump Shutoff Valve Is On
When Valve Handle Is In line with Chemical Pump ............................4-5
figure 4-5. Chemical Pump Shutoff Valve Is Off
When Valve Handle Is Perpendicular to Pump ....................................4-6
figure 5-1. Remove Valve Cap and Valve Assembly ..............................................5-7
figure 5-2. Inspect Manifold and Old Valves ..........................................................5-7
Figure 5-3. Replace Center Inlet Check Valve With Modified Check Valve ............5-8
figure 5-4. Apply Grease and Install Valves ...........................................................5-8
figure 5-5. Replace Valve Cap and Torque to 95 ft. lbs. (13 m kgs) .......................5-8
figure 5-6. Separate Manifold from Crankcase ......................................................5-9
figure 5-7. Seal Assemblies May Come Off with Manifold .....................................5-9
figure 5-8. examine Ceramic Plungers ..................................................................5-9
figure 5-9. Remove Stainless Steel Plunger Bolt and Ceramic Plunger ..............5-10
figure 5-10. Install O-ring, Apply Sealant and Slide Plunger over Plunger Guide 5-10
figure 5-11. extract Retainers and Seals .............................................................5-11
figure 5-12. Seal Kit and Insertion Tool for Seal Installation ................................5-12
figure 5-13. Install Seal Assembly using O-Ring Grease ....................................5-12
figure 5-14. Install Retainers into Cavities ...........................................................5-13
figure 5-15. Press low Pressure Seal Assembly into Cavity ...............................5-13
figure 5-16. Re-install Manifold and Torque fasteners ........................................5-14
figure 5-17. Torque Sequence in “X” Pattern .......................................................5-14
figure 5-18. Torque Bolts to 22 ft. lbs (3 m kgs) ...................................................5-14
figure 5-19. Recirculation fitting ..........................................................................5-16