Preparing the CTM-EF for operation
CTM-EF 1x3x Series
en
Page 27 / 52
BeWa CTM-EF 1x3x 4365310 en-us 2018-06-06.docx
2018-06-06
Connecting the CTM-EF
The CTM-EF is delivered ready-to-connect. Before starting it up please note
or check the following:
•
Read the installation and maintenance instructions for this module, the
CTM-SC-1xxx, CTU 1x4x-x-x-F, CTU 1x4x-x-x-A,
and
the instruction manuals for the CTM-SC-1xxx, CTU 1x4x-x-x-F, CTU
1x4x-x-x-A software carefully.
•
Take the support sieve supplied and put it in the membrane holder.
•
Clean the clean room by using the rinsing of the inner chamber until a
negative control value is achieved as listed in the table on page 22 .
Attach the connector to the control unit and the connection hoses of CTM-EF
to CTM-SC-1xxx, CTU 1x4x-x-x-F, CTU 1x4x-x-x-A as shown below:
The test item to be examined is marked with an X.
To prevent the connector from working loose, secure it by tightening the
locking ring.
The hose quick connectors must be pressed firmly onto the nipples, so that
the test liquid can flow.
