Recreational Vehicle/Marine
Water Filter System
RVF-10
Installation and
Operation Instructions
The RVF-10 system is designed to reduce foul tastes,
odors and sediment from potable drinking water.
This system includes 3/4" flexible hose couplings, and the
NCP-10 replacement cartridge.
NOTE: This system may reduce water flow slightly.
INSTALLATION
1.
Wrap the 3/8-inch fitting (on the 3/4-inch female hose
adapter) with Teflon
®
tape (included), and screw into
the INLET side of the filter system. Wrap the male
hose adapter with Teflon tape and screw into the
OUTLET side of the filter system. Use a wrench to
tighten firmly. DO NOT OVERTIGHTEN. About one
thread should remain visible when fittings are
tightened.
2.
To protect the system from possible damage, install
the system between two hoses. The short hose
(included) should be used to connect the outlet side of
the filter system with the storage tank inlet. A sanitary
hose can be used to connect the water faucet to the
inlet side of the filter system.
3.
Before running water through the RVF-10 system into
the storage tank, flush out any carbon fines that may
be present in the carbon cartridge. Disconnect the
hose at the storage tank and turn the water supply on
for approximately one minute. Turn off water supply
and reconnect the hose to the storage tank.
Installation is now complete.
WARNING: Do not use with water that is microbiologically
unsafe or of unknown quality without adequate disinfection
before or after the system.
CAUTION: The RVF-10 system must be protected from
freezing. Failure to do so may result in cracking of the filter
and water leakage.
®
