HMG 3010
Page 18
Edition 2013-03-26 - V04 R01
Part No.: 669855
6 Detailed Operating
Instructions
6.1 Settings Menu
Submenus of the Settings menu:
•
Change
settings
of
measurement
channels
•
Change display settings
•
Zero measurement channels
•
Change initial setup
•
Administer settings (save, load, ...)
•
Administer sensor configuration
(not visible unless the configuration of a
SMART sensor has been read out, see
section 6.4.2.5)
6.1.1 Change settings of measure-
ment channels
Select
Change settings of measurement
channels
to obtain a listing of all the chan-
nels available in the HMG (see screenshot).
There is a checkbox next to each of the
channels enabling you to switch the input
on or off (+
OK
key)
.
Activated channels
are marked by an
“X”
. To the right of the
checkbox is the
measurement range set-
ting,
the
unit
of measurement, and, as
applicable, a
designation
for the sensor,
e.g. "System pressure".
For connection to CAN-bus:
If the connection adapter ZBE 3010 is
plugged into D/H, the HMG 3010 automati-
cally switches channel D to
CAN-bus
and
channel H to
off
.
For all the setting options for
CAN-Bus,
see
Section 6.5‚
CAN Functions
.
