HYBREX GDS-600, Руководство по установке

Страница: 20 / 85

Issue 4.1.1 - October 2014
Installation
Caution 1. This system should be installed by qualified service personnel.
2. Do not install the Power Supply unless you have read the following instructions and
completed all the installation and wiring.
3. STATIC SENSITIVE DEVICES! Please handle with care.
Installing the Equipment
Backboard
Be sure to plan and allow enough space to mount and
connect the key service unit, power supply and system
battery back up if applicable.
Key Service Unit
Use the enclosed Hanging Template to locate the
mounting position for the Key Service Unit. Drill
appropriately spaced holes to fix the Hanging Template
and mount the KSU on the wall. When mounting the
KSU, make certain that there is adequate room for the
future system expansion and that the connecting power
cable between the power mains and the KSU. The same
applies for the battery back up unit.
Power Source
Dedicated Power Source - The power cord must be connected to a dedicated AC outlet.
Be sure that the third wire earth ground of the AC circuit is connected to a good electrical ground. If a music
source is installed, it must be connected to a separate AC circuit rather than the system's dedicated AC line cord.
Check Your Voltage Selection Jumper
Verify that the input voltage and input voltage jumper are correct before you power on the system. The input
voltage is set according to the Customer's requirement before shipping. However it is important to verify that the
setting is correct prior to initial system power up.
Power Supply voltage options for the unit:
100-VAC: 100 to 120 V AC (50/60Hz) or 240-VAC: 205 to 265 V AC (50/60Hz).