Husqvarna TX 125, Руководство пользователя

Страница: 49 / 146

12 SERVICE WORK ON THE CHASSIS
47
E00416-11
–
Tighten screws  .
Guideline
Screw, top triple clamp M8 17 Nm (12.5 lbf ft)
–
Tighten screws

.
Guideline
Screw, bottom triple clamp M8 15 Nm (11.1 lbf ft)
E00415-11
–
Position the brake caliper, and mount and tighten screws

.
Guideline
Screw, front brake caliper M8 25 Nm
(18.4 lbf ft)
Loctite ® 243™
–
Mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws

.
Finishing work
–
Install the front wheel. ( p. 82)
–
Install the headlight mask with the headlight. ( p. 91)
–
Check the headlight setting. ( p. 93)
12.7 Removing the fork protector
E00406-10
–
Remove screws

and take off the clamp.
–
Remove screws

and take off the left fork protector.
–
Remove screws  and take off the right fork protector.
12.8 Installing the fork protector
E00406-11
–
Position the fork protector on the left fork leg. Mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws

.
–
Position the fork protector on the right fork leg. Mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
12.9 Removing the lower triple clamp
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. ( p. 90)
–
Raise the motorcycle with the lift stand. ( p. 45)
–
Remove the front wheel. ( p. 82)
–
Remove the fork legs. ( p. 46)
–
Remove the front fender. ( p. 51)