Husqvarna TX 125, Руководство пользователя

Страница: 37 / 146

10 SERVICE SCHEDULE
35
10.1 Additional information
Any further work that results from the required work or from the recommended work must be ordered separately and can be
invoiced separately.
10.2 Required work
Every 40 operating hours/after every race
Every 20 operating hours
Once after 5 operating hours
Once after 1 operating hour
Check that the electrical system is functioning properly.
○ ● ●
Check and charge the battery. (All 150/250/300 models)
● ●
Check the front brake linings. ( p. 74)
● ●
Check the rear brake linings. ( p. 79)
● ●
Check the brake discs. ( p. 72)
● ●
Check the brake lines for damage and leakage.
● ●
Check the rear brake fluid level. ( p. 77)
● ●
Check the free travel of the foot brake lever. ( p. 76)
● ●
Check the frame and swingarm.
● ●
Check the swingarm bearing for play.
● ●
Check the heim joints at the top of the shock absorber.
● ●
Check the shock absorber linkage.
● ●
Check the tire condition. ( p. 85)
○ ● ●
Check the tire air pressure. ( p. 85)
○ ● ●
Check the wheel bearing for play.
● ●
Check the wheel hubs.
● ●
Check the rim run-out.
○ ● ●
Check the spoke tension. ( p. 86)
○ ● ●
Check the chain, rear sprocket, engine sprocket, and chain guide. ( p. 64)
● ●
Check the chain tension. ( p. 62)
○ ● ●
Grease all moving parts (e.g. side stand, hand lever, chain, ...) and check for smooth operation.
● ●
Check/correct the fluid level of the hydraulic clutch. ( p. 68)
● ●
Check the front brake fluid level. ( p. 72)
● ●
Check the free travel of the hand brake lever. ( p. 71)
● ●
Check the play of the steering head bearing. ( p. 50)
○ ● ●
Change the spark plug and spark plug connector.
●
Check the inlet membrane.
● ●
Change the gear oil. ( p. 108)
○ ●
Check all hoses (e.g. fuel, cooling, bleeder, drainage, etc.) and sleeves for cracking, leaks, and incorrect
routing.
○ ● ●
Check the antifreeze and coolant level. ( p. 95)
○ ● ●
Check the cables for damage and routing without sharp bends.
● ●
Check that the throttle cables are undamaged, routed without sharp bends, and set correctly.
○ ● ●
Clean the air filter and air filter box. ( p. 56)
● ●
Change glass fiber yarn filling in the main silencer. ( p. 58)
● ●
Check the screws and nuts for tightness.
○ ● ●
Check the headlight setting. ( p. 93)
○ ● ●
Check idle.
● ●
Final check: Check the vehicle for safe operation and take a test ride.
○ ○ ● ●
Make the service entry in the
Husqvarna Motorcycles Dealer.net
and in the Service and Warranty Book-
let.
○ ○ ● ●