Husqvarna TX 125, Руководство пользователя

Страница: 95 / 146

15 ELECTRICAL SYSTEM
93
15.9 Checking the headlight setting
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and
make a mark at the height of the center of the low beam headlight.
–
Make another mark a distance

under the first mark.
Guideline
Distance
 5 cm (2 in)
–
Position the vehicle vertically a distance

away from the wall.
Guideline
Distance
 5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. ( p. 93)
15.10 Adjusting the headlight range
Preparatory work
–
Check the headlight setting. ( p. 93)
F00363-10
Main work
–
Loosen screw

.
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the lower marking for
a motorcycle with rider (instructions on how to apply the marking: Checking the
headlight setting).
Info
If you have a payload, you may have to correct the headlight range.
–
Tighten screw

.
15.11 Changing the speedometer battery
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. ( p. 90)
V00421-10
Main work
–
Remove screws

with the washers.
–
Pull the speedometer upward out of the holder.
V00422-10
–
Using a coin, turn protection cap

all the way counterclockwise and remove it.
–
Remove speedometer battery

.
–
Insert the new battery with the label facing outward.
Speedometer battery (CR 2032) ( p. 131)
–
Check the O-ring of the protection cap for correct seating.