Husqvarna SMS4, Руководство по ремонту

Страница: 85 / 136

F1.49 Part. N. 8000 H4704 (07-2010)
88
91
89
90
ENGINE OVERHAUL
a.
Check that protrusion "a" on clutch control lever "1 " is aligned
to reference "b" on the crankcase as shown in the figure, by
manually pushing the clutch control lever in "c" direction until it
stops.
b. If protrusion "a" is not aligned to reference "b", align it as fol -
lows:
• Slacken the check nut "2".
• With clutch control lever completely pressed in "c" direction,
turn short clutch pushrod "3" towards the inside or the outside
until reference "a" is aligned to reference "b".
• Stop the short clutch pushrod to avoid its movement then tighten
the check nut as specified. (see fig. 88)
10. Install:
• Oil seal "1"
11. Install:
• Clutch casing
• Tighten the clutch cover bolts in the correct sequence as
shown in the figure.
12. Adjust:
• Clutch cable clearance
• Refer to "CLUTCH CABLE CLEARANCE ADJUSTMENT".
Clutch casing bolt •
10 Nm (1.0 mkg, 7.2 ft-lb)
Oil seal mounting depth "a" •
1.4-1.9 mm (0.055-0.075 in)
short clutch pushrod check nut •
8 Nm (0.8 mkg, 5.8 ft-lb)
9. Adjust:
• Clutch mechanism clearance