18
104 72 79-26
10.Setting the needle in centre position
Check 1
1. Insert a new needle size 90 universal in the machine.
2.The needle should always go its to the centre position, when the machine is turned on repeatedly.
Check 2 - using Service program
1. Go to the service program of the machine.
2. In Menu 1 Press
Key No 1
repeatedly - The needle should always go to its centre position in the A presser
foot.
Check of The gap between the segment (A) and the calibration stop (B)
1. Go to the service program of the machine.
2. In Menu 1 Press
Key No 1
- Needle to its centre position in the A-presser foot.
3. In Menu 1 Press
Key No 2
- The needle shall now take its left position.
The gap between the segment (A) and the calibration stop (B) should now be zero (0 mm).
4. In Menu 1 Press
Key No 5
- If the gap is ZERO (0 mm), the needle should not move in any direction,
5. In Menu 1 Press
Key No 1
- Needle to its centre position in the presser foot.
6. In Menu 1 Press
Key No 2
- The needle shall now take its left position.
7. In Menu 1 Press
Key No 4
- If the gap is correctly set, the needle should now move one small step to the
right.
NOTE!
The position of the eccentric of the calibration stop (B).
Settings
Needle point
0 mm
A
B
