Husqvarna 333RB Mark II, Руководство по ремонту, Страница: 13 / 48

6. Let the starter pulley rotate rearward until the spring
tension stops.
WARNING: Be careful, the recoil spring can
cause injury to your thumb when the starter
pulley rotates rearward.
7. Remove the screw (A), the washer (B), the pulley
(C) and the torsion spring (D).
C
B
D
E
F
G
A
8. Remove the starter pulley (E) to get access to the
recoil spring (F).
WARNING: Be very careful when you
remove the starter pulley. The recoil spring
can eject and cause injury to you.
9. Carefully remove the recoil spring (F) from the
starter housing (G).
7.3.2 To replace the recoil spring in the starter
housing
1. Disassemble the starter, refer to
To disassemble the
starter on page 12.
2. Put the recoil spring in the starter groove of the
starter housing.
3. Push down the recoil spring with your thumb on the
inner side of the starter housing.
4. Move your thumb around the edge of the starter
housing and push down the recoil spring turn after
turn.
7.3.3 To replace the starter rope in the starter
pulley
1. Pull the starter rope through the hole in the starter
pulley and tie a knot.
2. Make sure that the knot is as small as possible and
enters the groove on the starter pulley.
3. Wind the cord 3 turns counterclockwise around the
starter pulley.
4. Lubricate the recoil spring and the stub axle of the
starter pulley with cold resistant grease or thin oil.
1291 - 001 - 27.09.2019 Repair instructions - 13