EN
8
7.
OTHER KEYBOARD FUNCTIONS
8.
LED MEANINGS
LEDs on the front panel are intended to monitor the loads controlled by the device. Function
of each LED is described in the following table.
9.
CYCLE SELECTION PROCEDURE
1. Press CYCLE (3) key to go to C1, C2, C3, C4 freezing cycles and temperature maintenance
cycle. The character indicating the selected cycle is displayed on the screen.
NOTE: to switch to another cycle, simply press CYCLE (3) key when controller is in the standby
mode.
Temperature maintenance stage: to select H character, press CYCLE (3) key.
Cycles are preconfigured by the manufacturer as follows:
Cy1: quick cooling and preserving of the food (hard c soft cooling)
Cy2: cooling and quick freezing of the food (hard c soft c freezing cycle)
Cy3: direct quick freezing (quick freezing cycle only)
Cy4: quick freezing without ice layer formation (hard c freezing cycle)
HLd: temperature maintenance mode
dEF: manual defrosting activation
2. The selected cycle is in the controller memory and can be activated.
Cycle change procedure
1. Make sure no cycle is running. If a cycle is running, stop it by pressing and holding
START/STOP (2) key for 3 seconds.
2. Press CYCLE (3) key to go to C1, C2, C3, C4 freezing cycles and temperature maintenance
cycle. The character indicating the selected cycle is displayed on the screen.
