EN
2
IMPORTANT SAFETY INSTRUCTIONS!
READ CAREFULLY AND PRESERVE TO FIND THE REQUIRED INFORMATION WHEN OPERATING.
1.
INSTALLATION
IMPORTANT
■
Do not turn on the device immediately after transportation. Let it stand for at least 24
hours before plugging in.
■
Proper ventilation in the operation area of the device is a mandatory requirement of the
manufacturer.
■
Make sure you have installed all the accessories of the device before you turn it on.
■
Read this manual carefully.
1.1.
Placement and installation instructions
■
Unpacking
The device is shipped in a package containing a tray and heat-shrink tape. Documentation is in
a transparent packet inside the device. Take the protective plastic tape and cardboard off the
outer face of the device and the area around the door opening. Do not open the package with
sharp objects to avoid device surface damage. Remove all quality labels.
■
Put the device on a steady horizontal surface:
- the device may produce disturbing noise when placed on an uneven surface;
- uneven surface may cause a device failure;
- when installing the device on an uneven floor, take measures to level the device
horizontally.
■
Install the device indoors in a well-ventilated area:
- the device operates more effectively in properly ventilated
areas;
- to achieve maximum operating parameters of the device,
ensure 100 mm (4”) clearance between the room wall and rear
of the cabinet and 50
mm (2”) above the device;
- operating the device outdoors may reduce its operating
parameters and damage the cooler unit.
■
Do not install the device in highly humid and (or) dusty areas:
- humidity may cause device corrosion and reduce its operating parameters;
- dust collection on the condenser coil may lead to a cooler unit failure. Clean the condenser
at least monthly with a brush or clean cloth.
■
Do not install the device near the heat- and humidity-generating equipment:
- High ambient temperature causes a compressor overload resulting in increased energy
consumption and progressive device degradation.
■
The device shall not be exposed to precipitation and sunlight.
IMPORTANT In order to avoid corrosion, installing the device in a chloride- or acid-containing
environment (such as swimming pools, etc.) is prohibited.
ATTENTION: FAILURES CAUSED BY IMPROPER DEVICE PLACEMENT ARE NOT WARRANTABLE.
