INSTALLATION
13
■
Mark the screw holes.
■
Drill the screw holes using a
3
⁄
32
" drill bit.
■
Attach the battery mount using the screws provided.
CAUTION:
Only use the screws provided with the battery mount, designed so that the
screws will install flush with the mount. Protrusion of the screws could result in either the
battery wand not attaching properly, causing a failure to connect, or the wand falling out
of the mount. Do not overtighten.
■
Connect the power cable from the motor side into the power socket on the rechargeable
battery mount.
NOTE:
With longer cables, wire retainers (not supplied) are recommended to secure
the cable.
Insert the Battery Wand into the Battery Mount
NOTE:
The rechargeable battery wand ships fully charged, so it is ready to install out of the
package.
■
Match the direction of the arrow on the underside of the battery wand with the arrow on
the battery mount.
■
Insert the nose of the battery wand into the cavity of the battery mount.
■
Push the battery wand flush into the mount until the battery snaps into place.
CAUTION:
Failing to insert the wand properly may cause it to fall out of the mount,
posing an injury risk and potentially damaging the wand. Additionally, when mounting on
a door, closing the door with excess force may cause the battery wand to dislodge from
the mount, also posing an injury risk and possibly damaging the wand.
Proceed to “Testing the Shade” on page 16.
Battery Mount
Extension
Cable
(If Needed)
Power Cable
from Shade
