POWERVIEW
®
OPERATION
52
Using the PowerView
®
Remote
Refer to the illustration below to familiarize yourself with the controls on the remote. Activate the
remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT:
If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView
®
Shade Network” in the PowerView Motorization Remote Control Guide.
Joining a Louver Section to a Group
IMPORTANT:
The louver section will not operate using the remote until it has been joined to
a group.
NOTE:
If multiple louver sections must be joined to a group, it is recommended that they be
in different groups for individual operation, as well as in the same group for simultaneous
operation. (Note that any louver section can belong to more than one group.) Louver sections will
also operate simultaneously if their individual group buttons are selected, or the “all” button is
selected.
1. Press and hold
■
STOP on the remote until the indicator lights blink (approximately 6
seconds). The remote is now in program mode.
2. Press the desired group number (1 – 6) on the remote. The backlit group number will flash to
show it is selected.
3. While pressing the programming button on the rail with the corresponding louver section,
press
▲
OPEN on the remote. The green light flashes once and the louvers will move slightly
to indicate the louver section has joined the group. Release the programming button.
4. Press and hold
■
STOP on the remote until the indicator lights stop blinking (approximately 6
seconds).
Group 1
Group 2
OPEN
Tilt louvers
to the open,
horizontal
position
CLOSE
Tilt louvers to
the closed position
Group 3
Group 4
Group 5
Group 6
FAVORITE
(Default set at 45 degrees open)
LEFT ARROW
Tilt louvers down
RIGHT ARROW
Tilt louvers up
STOP
(Press and hold for
programming mode)
