22
hunter.direct/ICC2help
Installation Instructions
CONNECTING A HUNTER REMOTE
(NOT INCLUDED)
The ICC2 is compatible with both Hunter ROAM and
ROAM XL remotes, and each controller comes with a factory-
installed SmartPort. This provides instant remote connection
capability, which allows for manual operation of your system
without having to walk back and forth from the controller.
1.
To connect either a ROAM or ROAM XL remote kit to your
ICC2, simply remove the weather-resistant rubber cover
on the SmartPort, align the remote receiver’s pins with the
connector, and push firmly until the receiver is fully seated.
2.
Each ROAM and ROAM XL system is pre-addressed to
work right out of the box. Once you install the receiver into
the SmartPort, it will beep four times. After approximately
seven seconds, the receiver will again beep twice to
confirm it is programmed to the correct address. To verify
the transmitter and receiver are communicating properly,
press either the ► or stop button on the transmitter.
The receiver should beep twice, indicating proper
communication.
3.
Refer to the Hunter ROAM and ROAM XL Owner’s Manuals
for further programming instructions.