Hunter 44459, Руководство пользователя

Страница: 6 / 40

IMPORTANT
1 Read the entire installation section of this Owner’s
Manual thoroughly before you begin to install or
operate your Hunter Thermostat.
REMOVE THE MYLAR LABEL FROM THE LCD DISPLAY WINDOW.
INSTALLATION
2 All installation is normally performed at your
thermostat.
ARMCHAIR PROGRAMMING
3 You can program your thermostat before installation by
inserting the batteries and following the instructions
starting on page 16. This can be done while you relax in
your favorite chair and is a very good way to familiarize
yourself with all the functions of your Hunter Thermostat.
Note: At initial power-up this thermostat is programmed at 68°F
(20°C) for Heat and 78°F (26°C) for Cool. Any change to the set
temperature will be treated as a Permanent Manual Override. See
page 25 for more information. Press Auto Program to load the
built-in energy saving programs.
OPERATION
4 Your Thermostat is designed to operate with most gas,
oil, electric or 2-wire hot water heating and air
conditioning systems. It will also operate single-stage heat
pumps that do not have auxiliary or emergency heat.
These have 24-volt or millivolt control systems and
represent most central heating, air conditioning, or space
heating units in use in the United States.
This Hunter Thermostat will NOT control multi-stage heat
pumps or 110/220 Volt systems.
COMPRESSOR PROTECTION
5 The thermostat provides a 3.5 minute delay after
shutting off the heating or cooling system before it can
be restarted. This feature will prevent damage to your
compressor caused by rapid cycling. Note that this delay
also applies to the heating system control. It does not
provide a delay when there are power outages.
TEMPERATURE RANGE
6 Your thermostat can be programmed between 40°F
and 95°F (4°C and 35°C). However, it will display room
temperatures from 32°F to 99°F (0°C and 37°C). “HI” will
be displayed if the temperature is higher than 99°F (37°C),
and “LO” will be displayed if the temperature is lower than
32°F (0°C).
NOTE: The thermostat will automatically change to the Cool
mode if the thermostat measures a temperature over 99°F
(37°C). “Hi” will be displayed on the LCD, and the Cooling
system will turn On. Similarly, the thermostat will
automatically change to the Heat mode if the temperature is
below 32°F (0°C). “LO” will be displayed on the LCD, and the
Heating system will turn On.
Read This Before Installing Thermostat
PAGE 6
6-7
B99A p1-19 2/7/03 9:58 AM Page 6