Hunter 44459, Руководство пользователя

Страница: 12 / 40

PAGE 12
■
Remove the wallplate from your thermostat by pressing the
release tab on the bottom of the thermostat. (See Figure 2.)
■ Position wallplate on wall and pull existing wires through large
opening. Then level for appearance. Mark holes for plastic
anchors provided if your existing holes do not line up with
those on the Hunter wallplate.
■
Drill holes with 3/16” bit and gently tap anchors into the holes
until flush with wall.
■ Reposition wallplate to wall, pulling wires through large
opening. Insert mounting screws provided into wall anchor
and tighten. (See Figure 3.)
12-13 INSTALLATION
Mount Wallplate and Thermostat
NOTE: 5-wire Systems
If your thermostat has one wire marked R or RH (4-wire system), then leave the jumper wire between the RH and RC terminals on
the wallplate.
Otherwise, if you have separate RH and RC wires (5-wire system), then remove the jumper wire between the RH and RC terminals.
Figure 2
OB
RC
G
Y/Y1
W
RH
Figure 3
B99A p1-19 2/7/03 9:58 AM Page 12