19
Naming Channel (Models A and D only)
From the previous screen, shown above, Press
(NAME) to select
the name you wish to change, press the key until the name you wish to
change is indicated. You should see this screen:
Press
(INCREASE) or
(DECREASE) repeatedly to scroll
through the available channel names for an appropriate choice. Choices
for channel names are: CH1, CH2, CH3, CH4, LOAD1, LOAD2, LOAD3,
LOAD4, DISP1, DISP2, DISP3, DISP4, FLOW, STAB, PRES1, PRES2,
PRES3, PRES4, VOLU1, VOLU2, VOLU3 and VOLU4.
NOTE:
It is important to assign an appropriate name when naming
channels because the HM-2750 Series controller will choose a unit
of measure based on the name assigned. For example, if you are
configuring a load cell, name the channel Load 1, 2, 3 or 4. This
will ensure that the channel reads in lbs (kN). The same applies to
Displacement (DISP 1, 2, 3 or 4) reading in in/mm and Pressure (PRES1,
2, 3 or 4) reading in psi (kPa).
Once a name has been chosen for a channel Press
to return to the
previous screen. You should see this screen:
(LOAD1 was chosen as name):
“CH1” CONFIGURATION
* NAME =
“CH1”
* INCREASE
* DECREASE
“CH1” CONFIGURATION
* NAME =
“LOAD1”
* ENG MIN =
0
* ENG MAX =
“VALUE”
