Hughes HN9500, Руководство по установке

Страница: 32 / 136

5. Apply power by connecting the AC power cord to the surge connector.
The Power LED turns on, and various LEDs turn on and off as the router performs a self-test
and transitions to boot phase. (Indication that the self-test passed appears later as
Self Test
: Passed on the screen shown in Figure 20: Terminal Initialization Sequence in progress
on page 33.)
Figure 9: Powering up the router
A suitable surge protector is recommended to protect the satellite router from possible damage
due to power surges.
Connecting the installer laptop to the router
For this task you need an Ethernet cable.
To access the satellite router so you can perform the required installation procedures, you connect
your installer laptop computer to the router. After the router is installed and registered with the
satellite network, you connect the router to the customer’s computer or other device. During
router installation the installer laptop computer must be directly connected to the router without
any intervening connection.
Connect the installer laptop to the router:
1. Use an Ethernet cable to connect your laptop computer directly to either of the router's two
LAN ports, as shown in Figure 10: Connecting the installer’s laptop computer to the router
on page 19.
Do not connect the installer laptop to the router through an Ethernet router or switch.
HN9500 Satellite Router Installation Guide
18
1037736-0001 Revision G
Installing the satellite router Chapter 3