Hughes HN9500, Руководство по установке

Страница: 24 / 136

Installation checklist
Later in the installation process you are instructed to use the onsite validation tool (OVT) to
validate the installation. Validation ensures that the site is performing to acceptable standards.
To increase the likelihood that the site will pass validation the first time you try,
pay careful
attention to the items listed in the checklist below as you install the router, antenna, and
IFL cables
.
IFL cables
For specific cable information see Table 2: Related installation documents on page 11.
Use only Hughes-approved cables.
Do not exceed maximum length for the ODU type (such as 2 W or 4 W), cable type, and
cable part number.
Do not exceed the cable bend radius.
Properly terminate cables.
Connectors and connections
Use only connector types that are approved for the type of cable used. Check all connections
for tightness.
Outdoors:
Make sure F connectors connected to the radio assembly are tightened to 22 in-lb torque.
Carefully follow waterproofing procedures, using dielectric grease and Hughes-approved
weatherproof tape.
Power source
Before connecting the router power supply to the AC power source (using a surge protector),
use an AC outlet tester to verify that the power outlet is wired correctly. Wiring problems may
include:
• Hot and neutral wires reversed
• Neutral and ground wires reversed
• Open ground (incomplete connection)
• Open neutral
If the outlet is wired improperly, notify the customer that you are not permitted to connect the
system to a faulty outlet. Do not proceed with the installation until a properly wired outlet is
provided.
Grounding (router, antenna, radio, and IFL)
Adhere to Hughes grounding requirements.
Use only approved ground wires, ground blocks, lugs, and clamps.
For detailed information refer to the appropriate FSB, as listed in Table 2: Related installation
documents on page 11.
HN9500 Satellite Router Installation Guide
10
1037736-0001 Revision G
Preparing for installation Chapter 2