Huber Pilot ONE Unichiller 00 eo Series, Руководство пользователя

Страница: 56 / 86

Setup mode
OPERATION MANUAL Chapter 4
Unichiller® eo Desktop
V2.2.0en/09.08.21//17.12
56
4.2.9.2 Sub-category: “Display parameters”
In this function, the set manual parameters are displayed.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration manual”.

Tap on the sub-category “Display parameters”.

Tap on “OK” after you have read/checked the parameters.
4.2.9.3 Sub-category: “Control structure”
With this function, you have two different control structures available.
“Huber PID controller”:
Default setting
“Classic PID controller”: This setting is exclusively used by Huber service engineers for service pur-
poses.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Configuration manual”.

Tap on the sub-category “control structure”.

Choose between the dialogue entries “Huber PID controller” and “Classic PID controller”.

Confirm your choice by tapping on “OK”.
4.2.10 Sub-category: “Reset parameters”
With this function, you can reset the control parameters to the factory setting.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Reset parameters”.

Read the message and confirm it by tapping on “Yes”. The control parameters are reset/deleted.
The temperature control unit can only be operated again after a complete restart.

To do so, switch the temperature control unit off and back on again. The parameters have been
reset.
4.2.11 Sub-category: “Display parameters”
In this function, the set parameters are displayed. Depending on the previous setting, these will be
the “Automatic control parameters” or the “Manual control parameters”.
PROCEDURE

Go to the “Categories Menu”.

Tap on the category “Temperature Control”.

Tap on the category “TAC/Manual”.

Tap on the sub-category “Display parameters”.

Tap on “OK” after you have read/checked the parameters.