HUAWEI RP100-55T Room Presence
User Guide
12 Maintenance and Troubleshooting
Issue 01 (2013-12-20)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
81
Problem
Possible Cause
Solution
After the local site
joins a conference,
the remote video
can be displayed
continuously but the
video quality is not
satisfactory.
Contact and ask the
administrator of the remote
site to perform a local video
loopback test. If the video
quality is good, it indicates
that the video frame rate set at
the remote site is too high.
Contact and ask the administrator
of the remote site to disconnect
from the conference, reduce the
video frame rate, and then join the
conference again.
When the local site
is not in a
conference, the
local video is too
bright or too dark.
The video settings of the
RP100-55T are incorrect.
Set the video parameters of the
RP100-55T and the display to
default values.
The video settings of the
display are incorrect.
Set the video parameters of the
RP100-55T and the display to
default values. If the problem
persists, change the settings as
follows: If the video is still too
bright, set
Room light
to
Bright
.
If the video is too dark, set
Room
light
to
Dark
.
The camera is faulty.
Send the camera to the camera
distributor for maintenance.
After the local site
joins a conference
and a remote site
shares its computer
desktop, the VGA
display at the local
site cannot display
the computer
desktop of the
remote site.
The resolution of the computer
that is used for the VGA input
at the remote site exceeds the
maximum resolution
supported by the local
RP100-55T.
Contact and ask the administrator
of the remote site to change the
resolution and refresh rate of the
computer that is used for the VGA
input to a combination of the
values supported by the local
RP100-55T.
The local VGA display is not
supported.
Replace the VGA display.
A computer is
connected to the
local RP100-55T
but the local VGA
display does not
show the computer
desktop.
The capability of the VGA
display is limited. The
resolution or refresh rate of the
local SXGA output is too high
to be supported by the VGA
display.
Set the resolution and refresh rate
of the local SXGA output interface
to a combination of the values
supported by the VGA display.
The local RP100-55T supports
only certain combinations of
resolutions and refresh rates.
The combination of the
resolution and refresh rate set
on the computer that is used
for the VGA input, however,
is not supported by the
RP100-55T. Therefore, the
local site cannot display or
properly display the remote
computer desktop.
Set the resolution and refresh rate
of the computer used for VGA
input to a combination of the
values supported by the
RP100-55T.