Installation Manual
Quidway R2600/3600 Series Modular Routers
Chapter 5
Startup and Configuration
5-6
II. Initializing the system
If the router is powered on, the router will start self-check. When self-check is
completed, the terminal screen will display:
Press ENTER key to get start when you see ATS0=1
System now is starting ...ATS0=1
Press
<Enter>
and the screen will show:
Quidway>
This prompt indicates that the router has entered the normal configuration mode (as
described in “5.2 Configuration Basic”).
Note:
If ATS0=1 appears, it indicates that system initialization has completed and the router works normally.
5.1.4 Configuring Router via Setup
In Setup mode, you are guided in an interactive manner (dialog) to set the necessary
basic parameters for the router.
Setup is usually used for BOOTSTRAP configuration for the router when it is powered
on for the first time, or it can be used at any time in privileged configuration mode (as
described in “5.2 Configuration Basic”).
Configurations made in Setup include:
Global parameter:
z
Hostname of the router
z
Privileged
user
password
z
SNMP
z
IP
Parameters configured for the interfaces:
z
IP
address
z
IPX
address
The specific configuration steps are as follows:
I. Confirming whether to make the configuration
In privileged mode, enter
<Setup>
and the following information will be displayed on
the terminal screen:
Quidway#setup
--- System Configuration Dialog ---
Default settings are in square brackets '[]', if you do not change the default
settings, you may input enter. And Ctrl-C can cancel at any time without saving.
Continue with configuration dialog? [yes]:
y
“[]” contains the default system settings. If you do not want to change it, directly press
<Enter>
. Press
<Ctrl+C>
to exit setup mode at any time.
The last line prompts the user to continue with the configuration. Enter
<N>
to exit the
Setup mode.
