HST Addressable fire alarm MN-300, Руководство по эксплуатации

Страница: 7 / 26

Page 5
environment. If there are only a few display panels and the connecting lines are short, then ordinary
joining techniques may be used.
§2-2-3 Printer setup
Select Printer Setup in the menu, and the interface will display the following content.
Input 1 to make the printer registered and to enable its printing function; or input 0 to make the printer
unregistered and to disable its printing function. Set according to the actual need and press the
# key to
save the setup or the * key to go back.
§2-3 Alarm setup
Set Alarm setup in the main menu and press the # key to enter the interface with the following content.
When the cursor is at Loop setup , the user may press the # key to set the detectors and the modules.
The User may press
▲ ▼ ◀
or
▶
to move the cursor to select the option and then press the # key
to set the selected option or the * key to back.
Note: The system linkage setup and other setups will be set by zone, floor or room, so all the
data must be carefully recorded.
§2-3-1 Loop setup
Select Loop setup in the menu, and the interface will display the following content.
The “→” sign in the top right corner means that there is a page following the current page. After this
interface is set, the user may press the
▶
key to enter the next interface as follows:
The “←” sign in the top left corner means that there is a page before the current page and the system
may go back to the previous menu after the
◀
key is pressed. After this interface is set, the user may
press the
▶
key to enter the next interface as follows: