HST Addressable fire alarm MN-300, Руководство по эксплуатации

Страница: 15 / 26

Page 13
system of the zone where the alarm equipment is or of the neighboring floors.
Register =1, valid; Register =0, invalid.
Cross-floor: This
means that neighboring floors act at the same time. “0” means that cross-floor does not
exist; and “1” means that cross-floor exists.
Start: Bell and horn/strobe
Note: After the setup is finished, press the # key to save the settings and to set the next group, or
press the * key to go back to the previous menu.
Note: To make the linkage setup work, the Sounder Linkage and General Linkage on the panel
must be set in the auto mode, i.e. the Sounder Linkage and General Linkage indicators must be
on.
§2-3-4 Checking
Move the cursor to the checking option and then press the # key. After that, the following content will be
displayed.
Single point test: This can be done to test a specific piece of equipment.
Move the cursor to the
Single point test option and press the # key to start a single point test. The
following content will be displayed.
§2-4 Cancel setup
Move the cursor to the Cancel option and press the # key. After that, the following content will be
displayed.
The cursor points out the setting item to be cleared. Press
▲ ▼ ◀
or
▶
to move the cursor to the
wanted setting item easily, and then press the # key to clear the setting item. After that, there will be a
screen refresh; it shows that the data has been deleted.
§2-5 Hand control key setup
Move the cursor to the Manual option and press the # key. After that, the following content will be
displayed.
Key No.: The user may input key numbers 1~8 corresponding to the eight manual control buttons on the
panel. The corresponding positions are shown in the figure below.
Register =1, valid; Register =0, invalid.
Address: This refers to the address of the module to be started.