HSM VK 5012, Руководство по эксплуатации

Страница: 89 / 96

6.417.999.120
Issued 06/2005
6.25
Inspection and maintenance work VK 5012
6.14 Controls
Status for operation:
- Selector switch (1) at “RUN” position
- Green “RUN” LED (4) lights up
- Red “BATF” LED (5) does not light up
6.14.1 Loading a new program
Do not do this during strapping
Only to be performed by a qualified electrician
1. Set the selector switch (1) to “STOP”. (The baling press stops.)
2. Take out the existing memory card (2).
3. Plug in a new memory card.
4. Reset the CPU. Hold the selector switch (1) in the “MRES”
position for three seconds until the red “STOP” LED (3) lights up again.
5. Briefly hold the selector switch (1) in the “MRES” position. The red “STOP” LED (3) f
lashes for three seconds and then lights up continuously.
If the red “BATF” LED lights up, take out the battery and replace it.
Troubleshooting on the controls:
-> Fill in the following diagnostic form and fax it to HSM.
SIEMENS
L+
M
5
4
2
3
1
CPU 313
M
SF
BATF
DCSV
FRCE
RUN
STOP
RUN-P
RUN
STOP
MRES