HSM FP 1500, Руководство по эксплуатации, Страница: 23 / 56

FP 1500 Transport
FP 3000
Edition 03/2000 6.817.999.520
4 - 3
Transport with press ram in bottom position
Für transport within a plant it is normally sufficient to move the press ram into bottom
position to shift the centre of gravity of the barrel press. It must be checked that the
cylinder projects at the top (see Fig. 3-1).
➪
Move press ram into bottom position by pressing the "Lower press ram" soft-key.
➪
Press the "Press ram stop" soft-key when the bottom position is reached.
➪
Switch off the main switch.
➪
Take out the collecting basin for residual liquid and dispose the residual liquid in
an ecologically beneficially manner.
➪
Disconnect the current supply from the mains.
The barrel press can be transported to a different operating site when the transport
information (Section 4.1) is observed.
Transport with lowered cylinder
If vertical transport is not possible due to the projecting cylinder, the cylinder can be
retracted by loosening the cylinder flange (see Section 5.4).
➪
Put a timber on the bottom plate
• Height for timber - FP 1500: 350 mm
• Height for timber - FP 3000: 320 mm
Transport information
The timber's height has to be considered, otherwise the hydraulic hoses
can be teared off whilst lowering the hydraulic cylinder.
➪
Move press ram down by pressing the "Lower press ram" soft-key.
➪
Press the "Press ram stop" soft-key when the timber is reached.
☞