- 47 -
„control method“
Setting the engine control. „Set speed“ is the default setting. In the
„Regulate rpm“ control method the tool keeps the speed constant even
under stress.
„setting speed
Target
“
Sets the setting speed in % of the maximum speed. Recommended speed
for closing the clamping jaws, step1: 50 %, for final setting, step 2: 80 - 100 %.
„stop mode“
The selection between „no stop“ for switching between two steps and
„ECO stop“ for the last step is found in the drop down menu.
In the „strategy“ the conditions for the rivet setting can be defined.
The individual functions can be activated by clicking the on/off icon. Green means active,
grayed out means inactive.
stroke
„S
Target
“
S
Target
describes the stroke which the tool should use in this step. If this
value is reached the tool will switch to the next step.
„S
limit
“
S
limit
describes the maximum stroke which the tool should use in this
step. If this value is reached the tool will stop and display the NOK error
message.
current
„I
Target
“
I
Target
describes the current which the tool should use in this step. If this
value is reached the tool will switch to the next step.
