Their locations will vary depending on the needed space for the components being
used. To get a rough idea of where the Primary Supports should go take the
component space needed and add 4
¼
” to it. The bottom of the Primary Support
should be this distance from the bottom of the support above it. If there isn’t a
threaded hole at the distance needed, simply move it up or down to the next
closest hole based on the space needed for the component. Repeat this step until
all the remaining Primary Supports are in place. (See picture 5)
Picture 5
Step 4.
Take the last remaining Side Rail and place it on top of the Primary Supports
with the threaded holes facing down toward the supports and with the end of the rail in
the same orientation as the first rail already attached (See picture 6).
Picture 6.
