Step 1.
Your stand might be fully assembled. If so, skip to Step 7 and proceed.
To start assembling the RXR Audio Stand, locate one of the RXR Side Rails.
Place it with the side that contains the small threaded holes facing up. Take one
of the RXR Primary Supports
without
the threaded inserts and place it at the top
of Side Rail. The top of the Side Rail is the end that has a wooden cap on it. At the
top end all you see is wood; at the bottom end you will see two threaded inserts).
(See Picture 1.)
Picture 1.
Put two of the
¼
”-20 x 1” button head fastener with one
¼
” flat washers on each
of the screws in two holes that are diagonal from each other on the Primary
Support. Carefully with the fasteners sticking out through the support, line them
up with the corresponding holes of the Side Rail. The top Primary Support should
be just about level with the top of the Side Rail. (See Picture 2.) Only place two
fasteners in each side of the Primary Supports during the initial assembly of the
stand, the rest will be added in later.
Picture 2.
