Setup Instructions
The RXR Audio Stand consists of a frame structure and isolation bases that
support each component. The components required to assemble the frame are
shipped in one or more boxes. The number of boxes depends on the system size.
Each box containing parts for the frame will be marked with the model number
starting with RXR. All the wrenches required to put the frame together are
included with the shipment.
Work Surface
- Prior to unpacking any material, locate a very strong and very
stable work surface (capable of supporting 250 lb. load) or an area on the floor
that will give you a very soft scratch resistant work area that is at least three feet
by three feet in size. The more space you have the better, as it will give you room
to move around the frame to complete assembly. It is important that the area be
free of all dirt, screws or small pebbles, and that it is covered with a clean soft
protective blanket of same size that will prevent damage to high quality finish on
the frame.
Unpacking Assembly Hardware
- Remove all the contents from all the boxes
marked with RXR model number. Place all the hardware on a table adjacent to
your selected work surface and remove all the wrapping material. Be careful not
to drop or allow any of the parts to contact each other as they may scratch the
surface. Do not stack the parts on top of each other once they are removed from
the protective packaging material. To make assembly easier, group identical
parts together in an organized manner. Make sure all RXR Primary Supports are
the same size; also check that the RXR Side Rails and RXR Center Rail if needed
are the correct length.
This audio stand will be assembled on its side. Depending on what frame
configuration you have purchased there may be a number of Primary Supports
that have threaded studs already attached. Do not try to remove these threaded
studs as they are attached to the frame. These Primary Supports with threads will
be the bottom of the audio stand.