16
FH67 Series
●
0.5mm Pitch, 3.57mm depth One Action Lock, Vertical connection FPC/FFC/Shield FFC connector
[Notes for mounting on the board/after mounting on the board]
[Notes for board mounting]
Please be careful of the following at the time of board mounting.
[Caution]
· Please confirm recommendations for mount board land shape, metal mask opening shape, and FPC shape.
· If the land is narrower or if the metal mask opening is wider than recommended, solder (flux) wicking is more
likely to occur.
If there is difference from the recommendation, please use after checking the mounting state.
· The level difference between the bottom surfaces of contact lead and the mold is designed to be small.
When there is silk print etc. on the bottom surface of the connector, it could push up the bottom surface of the
connector and cause solder detachment or defective fillet formation.
When there is silk print etc. on the bottom surface of the connector, please use after checking the mounted state.
· Use the reflow conditions within the specifications of our company.
The mounted status may vary due to external conditions such as the paste solder type, manufacturer, and
board size. Please use it after checking the mounted state.
· Please control the board warpage as much as possible. While the coplanarity of this connector is 0.1mm or
less, defective soldering could occur if the board warpage is considerable.
· When mounted on FPC, be sure to provide a reinforcing plate to ease handling. We recommend a reinforcing
plate of 0.3mm or thicker made of glass epoxy material.
· When pulling out the emboss from the reel, or when the connector is picked from the emboss do not apply
any excessive external force (of 1N or more) to the connector before mounting.
[Cautions when handling the board after mounting]
Please be careful of the following when handling the board after mounting operation.
[Caution]
· Do not apply any load to the board in the assembly process, such as dividing a multi-piece board or securing
the board to the frame.
Applying a load to the connector may damage it.
· Use the board with the deflection being 1mm or less when the board width is 100mm. (Example 29)
If the board has some deflection, it could apply a load to the connector and damage it.
[Cautions for hand-soldering]
Please be careful of the following when hand-soldering for repair work etc.
[Caution]
· Do not hand-solder while FPC is inserted.
· Please be careful not to apply excessive heat or allow the solder iron to touch any place other than the
connector contact lead. Such action could cause the connector to be deformed or melted.
· Do not supply an excessive amount of solder (flux).
If too much solder (flux) is supplied to the contact, the solder or flux could adhere on the contact point and
cause contact failure.
Additionally, if you supply too much solder to the reinforcing metal tabs the rotational action of the lock lever
could be defective and the connector could be damaged.
(Example 29)
100
1 MAX
1 MAX
100
Connector
Connector
PCB
The characteristics and the specifications contained herein are for reference purpose. Please refer to the latest customer drawings prior to use.
The contents of this catalog are current as of date of 10/2019. Contents are subject to change without notice for the purpose of improvements.
2-6-3,Nakagawa Chuoh,Tsuzuki-Ku,Yokohama-Shi 224-8540,JAPAN
TEL: +81-45-620-3526 Fax: +81-45-591-3726
http://www.hirose.com
http://www.hirose-connectors.com
®
Sep.1.2020 Copyright 2020 HIROSE ELECTRIC CO., LTD. All Rights Reserved.