HRS CM-105, Инструкция по эксплуатации

Страница: 9 / 52

vii
Safety instructions in each category of work following the
delivery of the machine
Transportation
1. The machine shall be moved in such a way that secures safety avoid falling and dropping.
2. To protect against unexpected accidents or drop accidents, the machine shall be repackaged, if necessary, to
achieve the originally delivered state or better. Prior to repackaging, wipe off oil gathering on the machine.
Unpacking
1. The machine is shipped in a corrugated cardboard box. Be sure to take the machine out from the box
while cautiously avoiding dropping the machine.
Setup
(i) Cable and wiring
1. To avoid electric shock, leakage and fire, take care not to apply any extra load to the cables in service.
2. To avoid possible accidents caused by electric shock, leakage and fire, never put many loads on one
electrical outlet.
3. Be sure to securely connect connectors. In addition, be sure to detach a connector while holding the
connector section by hand.
(ii) Grounding
1. To avoid possible accidents caused by leakage or electrical strength, be sure to have an expert engineer
who have the electrical expertise to install an appropriate power plug to the machine. In addition, be sure
to connect the power plug to a grounded receptacle.
Before operation
1. To avoid possible personal injuries, be sure to check to ascertain that connectors and cables are not
damaged, dropped off or loosened.
2. To avoid possible personal injuries, keep your hands away from the moving parts of the machine.
Lubrication
1. Use oil of the kind designated by us or an equivalent for the machine.
2. In the event that oil should get in your eye or contact your skin, immediately wash to remove it to protect
against irritations and rashes.
3. In the event that you should swallow oil by mistake, immediately consult a doctor to prevent diarrhea and
emesis.
Maintenance
1. To prevent possible accidents caused by unfamiliarity with the operation of the machine, repair and
adjustment of the machine shall be conducted only by maintenance personnel who have a full knowledge
of the machine. Any repair and adjustment beyond the range covered by the instructions given in this
Instruction Manual is prohibited. We assume no responsibility for accidents caused by improper repair
or adjustment or the use of non-genuine part(s).
2. To avoid possible accidents due to unfamiliarity with the operation of the machine or electric shock
hazards, be sure to ask an expert engineer who have the electrical expertise or our technical personnel
to conduct repair and maintenance (including wiring) of electrical parts.
3. To avoid possible accidents caused by an abrupt start of the machine in the case of repair and
maintenance of any device such as an air cylinder that operates by the pneumatic pressure, be sure to
detach the compressed air supply pipe to expel the remaining air from the device.
4. To protect against personal injury, check to be sure that screws and nuts are not loosened after the
completion of repair/adjusting works and replacement of parts.
5. Periodically clean the machine as long as it is commissioned. To prevent possible accidents caused by
abrupt start of the machine during cleaning, be sure disconnect the machine prior to cleaning.
6. In the event that your machine fails to perform normally after repair or adjusting immediately stop
operation and contact us for service so as to protect against personal injury.