HRS CM-105, Инструкция по эксплуатации

Страница: 8 / 52

vi
Safety instructions
Basic safety instructions
1. Be sure to read this Instruction Manual and all the instructions and other materials supplied with the unit
as accessories. Save this Instruction Manual and make it available for review whenever necessary.
Safety device and warning labels
1. To avoid possible accidents due to lack of the safety device, be sure to operate the machine after
ascertaining that the safety device is properly installed at the predetermined position. Refer to page viii
for detailed description of the safety device.
2. Once the safety device is detached from the machine, replace it to its original position and check to be
sure that it properly functions.
Application
1. This machine shall only be used for its originally intended purpose while following the instructions
specified in this Instruction Manual. Hirose assumes no responsibility for any use of the machine other
than the intended use.
2. Modifications to this machine is prohibited. We assume no responsibility for accidents resulting from
modifications.
Operating environment
1. To avoid possible accidents caused by maloperation of the machine, use the machine under the
environment that is not affected by a substantial noise source (electromagnetic wave) such as a high-
frequency welder.
2. To avoid possible accidents caused by maloperation of the machine, never use the machine under the
environment where the voltage exceeds ±10% of the rated voltage.
3. To avoid possible accidents caused by maloperation of the machine, put any device such as an air
cylinder that operates by the pneumatic pressure into service after checking to ascertain that the
specified pressure is provided.
4. To ensure safety in operation, use the machine under the following environment.
Ambient temperature during operation: 5 ˚C to 35 ˚C
Relative humidity during operation: 35 % to 85 %
5. When the operating environment of the machine is suddenly changed such as in the case where it is moved
from a cold place to a warm place, dew condensation can occur. To avoid possible accidents caused by
breakage or maloperation of the electrical parts due to dew condensation, be sure to wait for a sufficient period
of time until there is no possibility of presence of water drops inside the machine before turning the power on.
6. To avoid possible accidents caused by breakage or maloperation of the electrical parts, be sure to stop
operation and disconnect the power plug for safety in case of thunder and lightning.
Training
1. To prevent possible accidents caused by unfamiliarity with the operation of the machine, the machine
shall only be allowed to be used by the operators who have been trained for proper operation and
provided with sufficient knowledge of safe operation by the employee. For this purpose, the employer
shall establish a training plan and implement it for the operators beforehand.
Working wear
1. To protect against possible accidents resulting in personal injury by your cloths being caught in the
machine, be sure wear a work uniform and securely fasten buttons on the sleeve cuffs and close the
zipper on the top center plait of the uniform, if any. Avoid wearing loosely fitted clothing.
2. The operator should fasten hair securely to avoid his/her hair from being caught in the machine.
3. The operator should wear close toe, rubber sole shoes.
Cases which require the power to be turned off
CAUTION
Turn-off of the power means the state where
the power switch is turned off and power plug
is detached from the receptacle. This will also
apply to the following.
1. If there is any sign of abnormal conditions or failure, or in the case of power failure, be sure to
immediately turn the power off.
2. To avoid possible accidents due to an abrupt start of the machine, be sure to turn the power off in prior
to inspection, repair or cleaning of the machine or before leaving from the machine.
3. Where it is necessary to detach the power plug, be sure to pull it out while holding, by hand, the plug
instead of the cord.