VDPLAT1
HQ POWER
8
d.
Receiver Settings
When installing the receiver it is necessary to calculate the position settings for the receiver JP1 switches. This is
calculated on the length of the tile screen in number of columns (L). The diagram below shows the receiver default
switch settings where a black square represents the position of the switch (i.e. JP2 switches 1-5 are OFF, switches 6
& 7 are ON). The installation of the receiver must be in accordance with the size of the tile screen. JP1 switches 3, 4,
5, 6, 7, 8 & 11 are control switches for the width in columns (W) of the tile screen.
JP1 switches correspond to the following values:
3 = +W32 4 = +W64 5 = +W128 6 = +W256 7 = +W512 8 = +W1024 11 = -W16
Example: An LED tile of width 22m would consist of 22 x 8 columns = 176 columns. The start value of JP1 is 32, so
therefore 176 = 32 + 144, referring to the table, receiver switches 5(W128), 3(W32) and 11(-W32) must be in the ON
position. Please refer to figure below for all columns and switch settings. The diagram below shows to correct
settings for the receiver with a width of the LED matrix screen of 176 columns.
