VDL25BM
- 2 -
VELLEMAN
4. Installation
a) Bubble Liquid
- Only fill the tank when the device is unplugged from the mains.
- Pour bubble liquid in the tank on the front of the device. Only use water-based bubble liquid (such as
VDLBL5
).
Non-recommended bubble liquid (oil or grease based) may damage the bubble machine and will void the warranty.
- The tank can be removed for cleaning purposes by removing the 2 screws on the left.
b) Fuse
- Only fit or replace a fuse when the device is unplugged from the mains.
- Replace a blown fuse with a fuse of the same type and rating (see “
7. Technical Specifications
”):
1. Unscrew the fuse holder at the back with an appropriate screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder and fasten it with the screwdriver.
c) Mounting the Device
•
Have the unit installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
•
The construction carrying the device should be able to support 10 times the weight for 1 hour without deformation.
•
The installation must always be secured with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device before bringing it into service and have him check the entire installation once a year.
•
Install the device in a location where people cannot reach it, walk by or be seated.
•
Do not attempt to install the device yourself if you lack qualifications as improper installation may result in injuries.
•
Make sure there is no flammable material within a 50cm radius of the device.
•
Have a qualified electrician carry out the electric connection.
•
Connect the device to the mains with the power plug. Don’t connect it to a dimming pack.
•
The installation has to be approved by an expert before the device is taken into service.
5. Use
-
VDL25BM
: plug the power plug into the mains to start the bubble machine. Pulling the plug will stop the machine.
-
VDL25BMR
: connect the power plug to the mains and press the button on the remote to switch the device on/off.
6. Cleaning and Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections, …
3. Mechanically moving parts must not show any signs of wear and tear.
4. The electric power supply cables should be undamaged. Have this device installed by a qualified technician.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts, except for the fuse (see “
4. Installation
”).
8. Contact your dealer for spare parts if necessary.
