Shenzhen Hpmont Technology Co., Ltd
Chapter 5 Operation Instructions
HD20 Series Inverters User Manual
―
33
―
Chapter 5 Operation Instructions
• Only when the inverter terminal cover has been fitted can you switch on AC power source. Do not
remove the cover after power is switched on.
• Ensure the motor and the mechnical device are in the use application before the inverter starts.
• Keep away from the inverter if the auto-restart function is enabled at power outage.
• If changed the PCBA, you should correctly set the parameters before operating.
• Do not check or detect the signal during the inverter operation.
• Do not randomly change the inverter parameter setting.
• Please thoroughly complete all control debugging and testing, make all adjustments and conduct a
full safety assessment before switching the run command source of the inverter.
• Do not touch the energy-depletion braking resistor due to the high temperature.
5.1 Function Description
Note:
In the following sections, you may encounter control, running and status of the inverter
description many times.
Please read this section carefully. It will help you to correctly understand and use the functions to
be discussed.
5.1.1 Inverter Run Command Source
It defines the source from which the inverter receives run commands (START, RUN, STOP, JOG).
There are three run command sources which can be selected through function parameter F00.11
and multi-function terminals:
Display panel:
Via
,
and
keys to achieve run, stop and jog operation control.
Control terminal:
Via control terminal to achieve start and stop operation control.
SCI communication port:
Via SCI communication to achieve start and stop operation control.
Danger
Warning
RUN STOP
JOG
5