HPE ProLiant DL20, Руководство по техническому обслуживанию и ремонту

Страница: 88 / 109

Item LED Status Definition
1 Locate Solid blue The drive is being identified by a host application.
Flashing blue The drive carrier firmware is being updated or
requires an update.
2 Activity ring Rotating green Drive activity.
Off No drive activity.
3 Do not remove Solid white Do not remove the drive. Removing the drive
causes one or more of the logical drives to fail.
Off Removing the drive does not cause a logical drive
to fail.
4 Drive status Solid green The drive is a member of one or more logical
drives.
Flashing green The drive is rebuilding or performing a RAID
migration, strip size migration, capacity expansion,
or logical drive extension, or is erasing.
Flashing amber/green The drive is a member of one or more logical
drives and predicts the drive will fail.
Flashing amber The drive is not configured and predicts the drive
will fail.
Solid amber The drive has failed.
Off The drive is not configured by a RAID controller.
The blue Locate LED is behind the release lever and is visible when illuminated.
IMPORTANT:
The Dynamic Smart Array B140i Controller is only available in UEFI Boot Mode. It cannot be enabled in
Legacy BIOS Boot Mode. If the B140i controller is disabled, drives connected to the system board Mini-
SAS connectors operate in AHCI or Legacy mode. Under this condition:
• The drives cannot be a part of a hardware RAID or a logical drive.
• The Locate, Drive status, and Do not remove LEDs of the affected drives are disabled.
Use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities to enable or disable the
B140i controller (System Configuration, BIOS/Platform Configuration (RBSU), System Options, SATA
Controller Options, Embedded SATA Configuration).
88 Component identification