HPE ProLiant DL20 Gen10 Plus, Руководство пользователя

Страница: 90 / 212

Installing a non-hot-plug LFF SATA drive Installing a non-hot-plug LFF SATA drive
The non-hot-plug LFF drives supported in this server do not require a drive caddy or a drive carrier to install. You only have to use the
drive screws preinstalled on top of the drive cage.
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following items available:
T-15 Torx screwdriver
Phillips No. 1 screwdriver
Procedure Procedure
1. If physically powering down a server with the front bezel installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Remove the correct number of screws from the drive cage. Each drive requires four screws.
9. If a non-hot-plug drive is already installed, disconnect the drive cables.
10. Remove the non-hot-plug drive cage.
Retain all screws for future use.
Installing a non-hot-plug LFF SATA drive 90