Page 22
Get Connected
HTTPS Configuration
Use this page to view and modify the Secure HTTP (HTTPS) settings on the device. HTTPS increases
the security of web-based management by encrypting communication between the administrative sys-
tem and the device.
To access the HTTPS Configuration page, click
Setup Network > Get Connected
in the navigation
menu, and then click the
HTTPS Connection
tab.
Figure 6.
HTTPS Management Access Page
Table 3.
HTTPS Management Access Fields
NOTE:
A power cycle does not reset the IP address to its factory-default value. If the configured IP address
is unknown, you can perform a manual reset to factory defaults to regain access to the switch (see
“Factory Defaults” on page 195
NOTE:
Changing the management port from the default configuration not only restricts access to the web UI
but also impacts the following protocols: DHCP, SNMP, SNTP, and TFTP.
Field
Description
HTTPS Admin Mode
Enables or disables the HTTPS administrative mode. When this mode is enabled, the
device can be accessed through a web browser using the HTTPS protocol.
TLS Version 1
Enables or disables Transport Layer Security Version 1.0. When this option is enabled,
communication between the web browser on the administrative system and the web
server on the device is sent through TLS 1.0.
HTTPS Port
The TCP port number that HTTPS uses.
HTTPS Session Soft Time Out
(Minutes)
HTTPS session inactivity timeout value. A logged-in user that does not exhibit any
HTTPS activity for this amount of time is automatically logged out of the HTTPS session.
HTTPS Session Hard Time Out
(Hours)
HTTPS session hard timeout value. A user connected to the device via an HTTPS
session is automatically logged out after this amount of time regardless of the amount of
HTTPS activity that occurs.
