HP Series 200, Руководство по установке

Страница: 31 / 144

If the router is not in the factory default state when you apply power, it
configures itself according to the configuration that was most recently
saved.
N o t e
The router does not have a power switch. The router is powered on
when you plug in the power cord, and automatically adapts to the
correct ac voltage range for your power source.
1. Plug the power cord into the router’s power socket and into an ac
power source.
2. Check these LEDs on the back of the router:
•
Power LED is continuously lit.
•
Self-test LED:
– lights during the self-test that automatically occurs after you
power on or boot the router
– turns off after a minute or two (when the self-test completes
and the router boots)
If either LED operates differently, refer to chapter 3,
“Troubleshooting”
Figure 1-19. Example of Power and Self-Test LED Positions for Single-Height Models
Power and
Self-Test
LEDs
I
n
s
ta
ll
a
t
io
n
1
Installation
Phase 3: Prepare the Router Hardware
1-23