Performing the Initial Hardware Setup
3-8
Hewlett-Packard VPN Server Appliance SA3110/SA3150/SA3400/SA3450 Installation Guide
8.
At the prompt, enter the IP address for the default gateway.
The default gateway is the gateway that provides a route to
the Internet. The VPN Gateway does not support Routing
Information Protocol (RIP) or any other form of dynamic
routing table updates. All other routing information must be
configured statically using the command shell (through the
console window) or VPN Manager.
9.
To set the Manager Password, enter
password
.
Note:
Note:
Note:
Note: Only the VPN Manager uses this password. It is not
used for Telnet, nor is it the console password; it is used as
an encryption key to encrypt communications between the
VPN Manager and the device. The factory-default manager
user name is
admin
.
Note:
Note:
Note:
Note: Passwords are case sensitive.
10. To set the time zone of the device, enter the time zone with
respect to Greenwich Mean Time. For example, to set the
time zone for Boston, enter:
timezone est 5 edt
11. To set the VPN device’s clock, enter the year, month, day,
hour (in 24-hour format), minute, and second. For example,
to set the system clock to December 31, 2000, at 2:18 p.m.,
enter the following responses for year, month, day, hour,
minute, and second:
00 12 31 14 18 00
The device now asks you if you want to save the setup
entries.
12. At the prompt, enter
Y
.
13. Test the interfaces using ping. At the prompt, enter
ping
and
the full IP address of the E0 interface.
ping 10.1.1.2 255.255.255.0
The device informs you of the success of the ping.
Note:
Note:
Note:
Note: The initial ping has a success rate of 80 percent as the
device must use the Address Resolution Protocol (ARP) to
resolve the physical address of the destination IP address.
14. At the prompt, enter
ping
and the full IP address of the E1
interface:
