Setting Up a Basic Routing Mode Configuration on a New Device
Hewlett-Packard VPN Server Appliance SA3110/SA3150/SA3400/SA3450 Installation Guide
3-7
Running the
Running the
Running the
Running the
Setup Script
Setup Script
Setup Script
Setup Script
You run the setup script to configure your new VPN device.
Notes:
Notes:
Notes:
Notes:
1.
You cannot communicate with a device from VPN Manager
until you run the setup script.
2.
Do not run the setup script on a device that has already been
configured.
3.
Words shown in square brackets provide examples of the
required information. They are not defaults.
4.
Every time you run the setup script, you must complete each
of the following steps 1-14.
To run the setup script:
1.
To get into setup mode, at the name-and-state prompt, enter
setup
.
The prompt changes to the following:
hostname (setup) #
Note:
Note:
Note:
Note: The word "setup" in parentheses means that you are
in setup mode.
2.
To set the host name of the device, at the prompt, enter the
name you want to call the device. For example, if you want
to call the device vpn1, enter
vpn1
at the following prompt
Enter Hostname [hostname]:
Hostnames are case sensitive.
The following message appears:
Bridge Mode On (Y/N)
3.
Enter
N
to disable bridge mode and set the device to routing
mode.
4.
At the prompt, enter the IP address for the red (private)
Ethernet interface E0.
5.
At the prompt, enter the subnet mask for the red (private)
Ethernet interface E0.
6.
At the prompt, enter the IP address for the black (public)
Ethernet interface E1.
7.
At the prompt, enter the subnet mask for the black (public)
Ethernet interface E1.