Hardware options installation 104
4.
Set the
Network Interface Adapter
field to
ON
, and then press
Enter
.
5.
Press
F10
to save your changes.
A message prompt to confirm the iLO settings reset appears.
6.
Press
Enter
to reboot the iLO settings.
7.
Press
Esc
until the main menu is displayed.
8.
Select
Reboot the System
to exit the utility and resume the boot process.
The IP address of the enabled dedicated iLO connector appears on the POST screen on the subsequent
boot-up. Access the Network Options screen again to view this IP address for later reference.
Redundant power supply option
Install the RPS backplane option to improve power efficiency and enable power redundancy. Power
redundancy requires the installation of two power input modules. This module is a separately purchased
option and is not part of the RPS backplane option kit.
When this RPS backplane and a single power input module are installed in the server, you can install or
remove a second power input module without powering down the server.
The HP 800-W/900-W Gold AC Power Input Module wattage rating changes depending on whether one or
two power input modules are installed in the server:
•
One power input module installed (non-redundant) = 900-W
•
Two power input modules installed (redundant) = 800-W
WARNING:
To reduce the risk of electric shock or damage to the equipment:
•
Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
•
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all
times.
•
Unplug the power cord from the power supply to disconnect power to the equipment.
•
Do not route the power cord where it can be walked on or pinched by items placed against it.
Pay particular attention to the plug, electrical outlet, and the point where the cord extends from
the equipment.
WARNING:
To reduce the risk of injury from electric shock hazards, do not open power
supplies. Refer all maintenance, upgrades, and servicing to qualified personnel.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION:
To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause ESD.
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP website (
http://www.hp.com/go/qs
).
Содержание ProLiant DL180 Gen9
