Removal and Replacement Procedures
2-28
HP ProLiant BL20p Generation 3 Server Blade Maintenance and Service Guide
System Board
To remove the system board:
1.
Power down the server blade and remove it from the server blade enclosure. Refer to the
“Server Blade Preparation” section in this chapter.
2.
Remove the access panel. Refer to the “Access Panel” section in this chapter.
3.
Remove the DIMMs. Refer to the “DIMMs” section in this chapter.
4.
Remove the processor and heatsinks. Refer to the “Processors and Heatsinks” section in
this chapter.
5.
Remove the fan assembly. Refer to the “Fan Assembly” section in this chapter.
6.
Remove the Smart Array 6i Controller. Refer to the “Smart Array 6i Controller” section
in this chapter.
7.
Remove the FC adapter. Refer to the “HP ProLiant BL30p Dual Port Fibre Channel
Adapter” section in this chapter.
8.
Remove the standard NIC mezzanine card. Refer to the “Standard NIC Mezzanine Card”
section in this chapter.
9.
Remove the SCSI backplane. Refer to the “SCSI Backplane” section in this chapter.
10.
Remove the power converter module. Refer to the “Power Converter Module” section in
this chapter.
11.
Remove the DC filter module. Refer to the “DC Filter Module” section in this chapter.
12.
Loosen the system board thumbscrews.
Figure 2-26: Loosening the system board thumbscrews
